Loosely attached the bellow assembly to "Case, Bottom.stl" using four "Bolt (M8 by 1.25 by 9.6mm).stl".I temporarily secured the bellow onto "Case, Bottom.stl" using four "Bolt (M8 by 1.25 by 9.6mm).stl" and allowed time for the bellow assembly to cure.įor final assembly, I performed the following steps: Pressed the exhaust manifold assembly onto the bellow assembly making sure the mounting holes aligned.Spread a thick bead of silicon adhesive on the exhaust valve assembly around the outline of the rectangular hole in the exhaust manifold assembly.Pressed the exhaust valve assembly onto the exhaust manifold such that the valve side of the valve assembly was inside the rectangular hole.Spread a thick bead of silicon adhesive around the rectangular hole in "Exhaust, Manifold.stl".Using a small dot of thick cyanoacrylate glue on the very end of the arm on "Exhaust, Valve.stl", I attached the exhaust valve to "Exhaust, Gasket.stl" such that the valve was centered over the exhaust valve hole and the arm pointed to the center intake hole.With a slight rotating motion, pressed the hemisphere into the bellow base assembly carefully rotating it to make sure it was completely seated, then set the assembly aside to cure.
0 Comments
Leave a Reply. |